Engineering Center

in the software, i can only choose HST3-R M12 and M16, how can i choose other anchor bolts

How can I choose the design method Hilti SOFA in PROFIS ENGINEERING

Does the Hilti PROFIS design method selection in HK for approve , it does choose ETAG 001 ANNEX C FOS 3 ?

Please send me the BD approval document showing which types of anchor bolts are in the BD bank list.

Shall Hilti provide free vetting service on design and calculation using Hilti software?

Is the software for design and calculation of anchor bolt approved by BD? If so, please let me know its BD reference no. Thanks.

Hi , we have a design of anchor plate on cantilever case . However , the system said it is not okay. Please advise.

Is RE100 applicable for M39 Grade 8.8 Bolt? Since I cannot find M39 8.8 Bolt in the Catalogue, only up to M30. With reference to the Catalogue, RE100 can apply to Rebar up to Dia.40, but in the PROFIS Engineering software, there is only up to Dia.32. So Dia.40 Rebar is applicable or not? Is it a must to use PROFIS Engineering ...

we are in the process of as-built checking for the steel frames in a tunnel. For sake of conservative, the seismic load was considered in the original design, and 3.0 FOS was adopted as well. And the utilization of the hilti anchor bolt is 105% currently. Question: is 3.0 fos compulsory for the highway's job? If not, could yo...

I would like to use HSA M10 to design. However, there is no option of HSA anchor to select in https://profisengineering.hilti.com/. Please advise.