Engineering Center

can we have more than 2 number of rebar layers . because in the software we can only select 2 layer max. how about more than 2?

Please advise minimum embedment depth of rebar for repairing concrete spalling at non structural wall using Hilti HY200R

may i know the pull out test sample frequency for HST3 according to BS 5080-1:1993, thanks

I joined a webinar MEP 101 - Modular Solution - Installation System in 22 July 2022 and I got an email for thanking me to show up. However, I haven't received the certificate. Could you please send me the cert? Attached the email to proof that I have joined the section. Thanks!!

I have joined the webinar, where can i find the cpd certificate. thanks

If contractor is required to apply epoxy paint on walls, what type of paint could we recommend for them to use.

Dear Sir/Madam, I am writing to seek your advise on the design assumptions by PROFIS model. Referring to the Post-Installed Reinforcing Bar Guide by Hilti, it is noted from the design example of post-installed rebar (p.37) that the minimum reinforcement area for crack control would be controlled by 3 equations as shown belo...

Hi. If the design load is far less than recommended load. Should use 1.5 time design load instead of recommended load for load test?

After my online session, my certificate don't have my name shown

I need to use FOS3 for submission. Do I then input the factored load from ULS combo (controlling case: 1DL 1.5W) or just the working load (controlling case: 1DL 1W)?